Hardware Options Installation; Introduction; Processor Option - HP ProLiant ML100 Series User Manual

Hardware options installation

Introduction

If more than one option is being installed, read the installation instructions for all the hardware options
and identify similar steps to streamline the installation process.
WARNING:
internal system components to cool before touching them.
CAUTION:
beginning any installation procedure. Improper grounding can cause electrostatic discharge.

Processor option

The server uses embedded PPMs as DC-to-DC converters to provide the proper power to each processor.
CAUTION:
or cache sizes. Refer to the label on the processor heatsink for a description of the processor.
CAUTION:
should attempt to replace or install the processor in this server.
CAUTION:
• Handle the processor only by the edges.
• Do not touch the bottom of the processor, especially the contact area.
IMPORTANT:
function.
To install the component:
Power down the server (on page 7).
1.
For the ML110 G6 server, extend the server from the rack.
2.
For the ML150 G6 server, do one of the following:
3.
Unlock and remove the bezel ("Remove the tower bezel (ML150 G6 servers)" on page 8).
o
Extend the server from the rack.
o
Remove the access panel (on page 7).
4.
Open the processor retaining latch and the processor socket retaining bracket.
5.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, properly ground the server before
To prevent possible server malfunction, do not mix processors of different speeds
To avoid damage to the processor and system board, only authorized personnel
To avoid damage to the processor:
Processor socket 1 must be populated at all times or the server does not
Hardware options installation 14