Expansion Board Options - HP ProLiant ML100 Series User Manual

Extend the server from the rack.
o
Remove the access panel (on page 7).
4.
Remove the air baffle.
5.
For more informati
(http://www.hp.com/go/bizsupport).
Open the DIMM slot latches.
6.
Install the DIMM.
7.
Install the air baffle.
8.
Install the access panel.
9.
For ML110 G6 servers, slide the server
10.
For ML150 G6 servers, do one of the following:
11.
Close or insta
o
Slide the server back into the rack.
o
If you are installing DIMMs in lock-step configuration, c
Utility" on page 38).
For more information about LEDs and troublesh
the HP website (http://www.hp.com/go/bizsupport).

Expansion board options

For server -specific expansion board installation instructions, refer to the installation sheet that ship
the server.
CAUTION:
and remove all AC power cords before removing or inst
To install the component:
Power down the server (on page 7).
1.
For ML110 G6 servers, extend the se
2.
on, see the server installation sheet on the HP website
back into the rack.
ll the tower bezel, as needed.
To prevent damage to the server or expansion boards, power down the server
rver from the rack.
onfigure this mode in RBSU ("ROM-Based Setup
ooting failed DIMMs, see the server installation sheet on
alling the expansion boards.
s with
Hardware options installation 29