Table of Contents
Advertisement
Example 2
Connect the +12V Power Output of the VBrick through a switch to the event pin on the
COM1 port.
Example 3
Connect COM1 output pin (pin1 RTS or pin2 DTR) through a switch to a COM1 event pin.
For this method to work, you must force the desired output pin (RTS or DTR) to On via
IWS:
To force the desired output pin to On:
1. Go to the
Configuration: Passthrough
2. Change COM1
3. Change
RTS/DTR Control
4. Change COM1
5. Click
Save Config
VBrick Appliance Getting Started Guide
page in IWS.
to
Passthrough State
Responder
to
and click Apply.
Force On
to
Passthrough State
Disabled
when done.
VB6000 Reference
and click
.
Apply
and click
.
Apply
73
Advertisement
Table of Contents
