Table of Contents
Advertisement
of the computer or terminal device (usually
Connecting with HyperTerminal on page 49 for more information.
2. From the Windows start menu, go to:
Communications > HyperTerminal
3. The port setting is 9600, 8-bit, 1-stop, no parity, flow control = none. The VBrick is a
DTE and the provided serial adapter cable and connector provide connectivity from the
VBrick
COM2
4. Press Enter to see Login.
5. The default Login and Password is
for both Login and Password.
6. Type
to become the active Editor. Pressing
be
configuration changes as desired.
7. Change the IP Address of the device manually so that it will be recognized on the
network to which it is connected: If the network is not running DHCP,
8. Type
c nt 3 xxx.xxx.xxx.xxx
9. Enter a subnet mask:
10. Type
c nt 4 xxx.xxx.xxx.xxx
11. Enter a gateway address if required:
12. Type
c nt 5 xxx.xxx.xxx.xxx
13. Enter
Apply
address, subnet mask, and Gateway configured.
14. MPEG appliances only. Connect the VBrick to another VBrick over the network using an
Ethernet switch. For unicast, the destination IP Address of one VBrick should be the IP
Address of the other VBrick. Make sure the respective destination and receive ports also
match.
Step 6. Install StreamPlayer Plus
StreamPlayer Plus is used to view streams and verify operation. WM appliance operation can
be verified using StreamPlayer or Windows Media player. MPEG-2 or MPEG-4 appliances
can be verified only with StreamPlayer.
To install StreamPlayer:
1. If you did not purchase StreamPlayer go to www.vbrick.com/products/software.asp web
page to download a 30-day evaluation copy and get a demo license file.
2. If you did purchase StreamPlayer, display the contents of the Product CD with Windows
Explorer.
3. Open the StreamPlayerPlus folder and run the
4. Browse to the location where you saved your license file or demo file when prompted.
5. Finish the installation.
Step 7. Verify Operation
Use one of the methods below, depending on the type of VBrick you are installing, to verify it
is set up and operating properly.
6
.
to the PC
or
COM1
COM2
admin
where xxx is the IP Address.
to implement these changes and confirm with
) using the provided cable. See
COM1
Start > Programs > Accessories >
.
(case sensitive). Type
displays the VBrick menu. Make
?
. The box reboots with IP
y
SetupStreamPlayerPlus.exe
and press Enter
admin
program.
© 2008 VBrick Systems, Inc.
Advertisement
Table of Contents
