Table of Contents
Advertisement
Host Names has an
to specify how the address is to be configured: IP Address or Host Name. If
is set to "Host Name," the IP address field becomes a status field and is used to report the IP
Address of the configured Host Name. Likewise, if
the Host Name field is used to report the Host Name of the configured IP Address. If the
configured IP address is multicast, the Host Name field will be blank. The following rules
apply:
•
The following addresses can be configured using Host Names:
Encoder network destination address
Pump network destination address
Decoder network receive address
Recorder network receive address
Passthrough dedicated address
•
Multicast addresses cannot be configured using Host Names.
•
The
Management SAP Transmit
for this feature to work.
Enabled
•
The Host Name feature does not work if the appliance is in edit mode. Please exit Edit
mode when finished configuring the appliance.
IP Differentiated Services (Diffserv)
Type of Service settings control the level of priority a service or source receives while
traveling through a network. VBrick supports setting the IP TOS (Type of Service) in
accordance with RFC-791, RFC-1112 and RFC-2474 (Differentiated Services Field in the
IPv4 Header). You can set the Type of Service field in the IP header to any value, decimal 0
to 255.
Table 5. TOS Settings
Priority Level
111
110
101
100
011
010
001
000
Bit 3
Bit 4
Bit 5
VBrick Appliance Getting Started Guide
parameter. This configuration parameter allows the user
Address Mode
parameter of the referenced VBrick has to be set to
Type of Service
Network Control
Internetwork Control
CRITIC/ECP
Flash override
Flash
Immediate
Priority
Routine
0 = Normal delay
1 = Low delay
0 = Normal throughput
1 = High throughput
0 = Normal reliability
1 = High reliability
Streaming Video Basics
is set for "IP Address,"
Address Mode
Address Mode
23
Advertisement
Table of Contents
