Table of Contents
Advertisement
4. Go to
Start > All Programs > VBrick > VBDirectory
VBDirectory program should launch in a new window showing all VBrick appliances
that are available for upgrade.
5. Select the device to be updated by highlighting the name and then click the
button. (If the user name and password are not set, a dialog box will appear and you will
need to configure the appliances's username and password using the
button.)
Password
6. In the VBDownload window, if you installed the release to the default directory, that
directory will be auto-selected in the
that contains the unzipped files from the release package.
7. Select a
Revision
VBDownload is
which release components need to be downloaded. When prompted, press
VBDownload to upgrade the suggested components. This may take several minutes.
8. When you receive a
radio button and following the prompts (or use the
Reset Unit
remote).
9. Note that part of the upgrade takes place during the first boot after the download and
may take up to 15 minutes. You can tell the update is complete when you can login via
IWS or CLI or when the device name entry re-appears in VBDirectory.
10. When done close the window or click
Note To verify the download has successfully installed, check the
Go to
Status > System Information > Release Revision
10
Revision Folder
and press
to start the download. Since the default mode of
OK
the utility will query the VBrick to determine
Intelligent Download
Download Complete
Exit
to start the management utility. The
. If not,
Browse
window, reboot the appliance by using the
Reset
.
Release Revision
.
© 2008 VBrick Systems, Inc.
Upgrade
Enter Username/
to the directory
to allow
OK
button on the IR
in IWS.
Advertisement
Table of Contents
