Figure 4 Mounting Of Wind Sensor - Vaisala WAV151 User Manual

Chapter 3 __________________________________________________ Installation
VAISALA__________________________________________________________11
Always mount the WAV151 Wind Vane to the northern end
of the cross arm.
1. It is recommended that you remove the vane assembly
to ease installation.
2. Fit the 10-pin cable plug through the mounting flange
at the end of the cross arm, then connect it to the
sensor. See Figure 4 below.
3. The sensor fits to the cross arm in one position only.
Face the product label north and mount the sensor to
the flange by twisting. Note that the plastic washers (1)
should be inserted between the flange and the sensor.
See Figure 4 below.
4. Finally, tighten the screws (2) with an Allen key (3).
See Figure 4 below.
5. Mount the vane assembly and tighten its fixing screw.
Figure 4 Mounting of Wind Sensor
0204-042