Barco LED-PRO User Manual page 85

•
•
•
•
•
•
•
lîÉêp~ãéäÉ=qáãáåÖ=^Çàìëí=jÉåì
When OverSample is selected, the Oversample Timing Adjust Menu is shown:
O V R S M P T I M I N G A D J U S T
> Rig ht Edge
Figure 4-53. OverSample Timing Adjust Menu (sample)
Following are descriptions of each menu function, which are only available when
OverSample is selected.
•
•
•
•
LED-PRO • User's Guide
Sample Phase — enables you to fine-tune the image by adjusting the sample
clock phase. Please note:
~
The adjustment range is -16 to 15.
~
Zero is the default setting.
~
The value is initially filled in by the Auto Config command, or set to the
default.
H Total — enables you to adjust (in pixels) the total pixel count per line.
Note H Total cannot be adjusted if the input type is DVI or SDI.
H Position — adjusts (in pixels) the offset of the start of active area from H sync.
H Active — adjusts (in pixels) the size of the active area.
V Total — adjusts (in lines) the total line count per frame.
V Position — adjusts (in lines) the offset of the start of active area from V sync.
V Active — adjusts (in lines) the size of the active area.
Tip When adjusting input timing, turn on the Output Raster Box,
and adjust the input image to align with all four edges of the
raster box.
Left Edg e
Top Edge
B o t t o m E d g e
Right Edge — adjusts (in pixels) the right edge location, relative to the start of H
Sync.
Left Edge — adjusts (in pixels) the left edge location, relative to the start of H
Sync.
Top Edge — adjusts (in lines) the top edge, relative to the start of V Sync.
Bottom Edge — adjusts (in lines) the bottom edge, relative to the start of V Sync.
Tip When adjusting input timing, turn on the Output Raster Box,
and adjust the input image to align with all four edges of the
raster box.
4. Operation
Using the Expert Mode Menu
2096
496
49
1249
71