Using The Setup Wizard - Barco LED-PRO User Manual

4. Operation

Using the Setup Wizard

rëáåÖ=íÜÉ=pÉíìé=táò~êÇ
The Setup Wizard allows users to quickly set up and align a basic LED display — without
the need of the Director Toolset. The Wizard automatically guides the user through the
entire setup process, including:
•
•
•
•
Please note the following important points:
•
•
Use the following steps to run the Setup Wizard:
1.
Horizontal Cabling
Figure 4-31. LED Tile Cabling Examples
2.
56
Wall detection (type and size)
Addressing and positioning tiles
Aligning LED-PRO's output resolution to match the wall
Wall contrast and gamma adjustment
The Wizard can only be used with standard LED Tiles. MiPIX, MiSPHERE and
creative OLite displays require the Director Toolset.
The Director Toolset is still required for wall color calibration, tile firmware
updates, and for creating and applying custom gamma curves.
Please note the following important Setup Wizard prerequisites:
~
Ensure that your LED wall is properly connected to LED-PRO, and that
power is enabled to all devices.
~
Ensure that you know how your LED wall is cabled (e.g., horizontally or
vertically), as shown below:
Vertical Cabling
~
Ensure that you know where your "first" LED tile is located, as viewed
from the front of the wall (e.g., the bottom left). This is the tile to which
LED-PRO (or Fiberlink) is connected.
From the Setup Menu, select Setup Wizard to display the Setup Wizard Start
Menu.
LED-PRO • User's Guide