Usb Connection; Cable Routing - Barco E-2320 C Installation & User Manual

Installation

USB connection

If the display receives video from a Barco-supported display
controller, it is not necessary to establish a USB connection to use
the nioWatch software.
If this is not the case, you must connect the USB cables if you
wish to use the nioWatch software.
Moreover, the USB connection allows you to use the display as
USB hub, to which you can connect USB devices, such as a
keyboard, mouse or digital camera.
To connect the USB cable:
1. Connect the display's USB upstream connector to the USB
port of the PC by means of a USB cable.
2. Connect any USB device to any of the display's USB
downstream connectors.

Cable routing

Routing the signal cables
• Bind the cables in the connector compartment together with
the cable tie inside the connector compartment.
24
Figure 10
E-2320 C