Barco E-2320 C Installation & User Manual page 16

Introduction
1. Control wheel
The control wheel can be pressed like a push button and
rotated like a knob.
It allows to put the display in stand-by, navigate through the
on-screen display (OSD) menus and change values in the
OSD.
2. USB downstream port. See also item "6." on page 17
3. Power LED
The LED is off when the display is disconnected from the
power. The LED is also off when the LED function is disabled
in the on-screen display (OSD).
The LED is green when the display is on (when enabled in
the on-screen menus).
The LED is orange when the display is in Stand-by power-
saving mode.
Rear
1. Connector compartment cover
To get access to the connectors, remove the cover by pulling
down the 2 clips at the top of the cover.
16
Figure 2
E-2320 C