Display controller installation
Using the VGA capabilities of the BarcoMed 2MP2CP display controller
Prior to installing the BarcoMed 2MP2CP controller, decide if you
are going to use its on-board VGA capabilities. If you are, check
the setting of the switches at SW1 on the display controller (see
figure 7 below). By default, VGA should be enabled, switch 1 on
and switch 2 off. If you decide to use a separate VGA monitor as
your boot monitor, you must disable the BarcoMed 2MP2CP's on-
board VGA capabilities by changing the switch settings to switch
1 off and switch 2 on.
Color Coronis 2MP
Figure 6: The BarcoMed 2MP2CP display controller
35