Troubleshooting
necssary attach the second display by right clicking on the
rectangle that represents it and selecting "Attached".
Now repeat steps 4–8 above for this display.
If you are using a Quad-Head Configuration repeat all of the
above steps for the two displays on the second display controller.
Caution: if you have a single display configuration and you have
enabled DualView, Windows will not allow you to attach the
second head. This is normal and not a bug.
Figure 43: The Windows Display Properties Control Panel Settings
Tab after the drivers have been installed and the resolution set
Note: The system shown in figure 43 above is a dual-head, single
BarcoMed 2MP2CF-3D display controller, without a 3rd party VGA
controller configuration. Your system may look different.
Color Coronis 2MP
with DualView Enabled.
145