Table of Contents
Advertisement
General tips
For the display which is still attached click Click on the
4.
"Advanced" Button.
Select the "Adapter" tab and then click on the "List All Modes"
5.
button. Select the resolution and refresh rate that your Nio display
supports from the dialog box and click "OK".
In the Adapter box, the Adapter string shows if this display
Note:
is the First View or the Second View attached to the display
controller. Please make a note of this, so that you can arrange the
displays in the correct order later if necessary.
Click "OK" on the bottom of the Adapter Control Panel. If the "OK"
6.
button on the bottom of the Adapter Control Panel is not visible,
press the "TAB" key once and then press "CTRL"+"Enter" to
select "OK".
Click "OK" in the "Windows will now apply your new desktop
7.
settings" dialog box. Your Nio display should now synchronize and
display the Windows desktop.
Click "Yes" when asked, "Your desktop has been reconfigured. Do
8.
you want to keep these settings?"
To set the resolution of the second display attached to the
BarcoMed display controller you are working with, go back to the
"Settings" tab of the "Display Properties Control Panel". If necssary
attach the second display you detached in step 2 above, by right
clicking on the rectangle that represents it and selecting
"Attached".
Now repeat steps 5-8 above for this display.
If you are using a Quad-Head Configuration repeat all of the above
steps for the two displays on the second display controller.
Note: If you have a single display configuration and you have
enabled DualView, Windows will not allow you to attach the
second head. This is normal and not a bug.
After enablingDualView and setting the resolutions in a Quad-
Head Configuration you may need to drag the heads into the
proper position in the window on the "Settings" tab, so that the
Nio systems
93
Advertisement
Table of Contents
