Barco Nio systems Installation & User Manual page 47

Software installation
Reinstalling drivers
You can install new drivers or reinstall existing drivers at any time by
using the Barco Set-up wizard on your Barco system CD-ROM, see
Installing the B
ARCO
page 44 of this manual.
Uninstalling the drivers and software
To un-install the B
documentation, please use the Windows Add/Remove Programs utility.
This can be found in the Windows Control Panel.
Note: If you installed your
DualView enabled, the wizard may warn you that DualView must be
disabled before the drivers can be un-installed. This is normal, please
follow the prompts from the wizard.
Command line (Silent) Install of Drivers and Software
Specifying the silent install option causes most of the GUI associated
with the installer to disappear. A background progress window will still
be visible, but no user input will be required.
The silent install behavior is dictated by the SETUP.INI file. Each
application is allowed to have separate command-line parameters for
normal and silent installs.
To install the drivers and software silently, please follow the steps
below:
Insert the B
1.
ARCO
CD/DVD drive. When the Barco Product Installation Wizard starts
click "Cancel".
Click the Start button in the task bar.
2.
Click Run.
3.
Click Browse and
4.
browse to the root directory of the B
a)
D
ISPLAY
Nio systems
display controller drivers and software on
M
ED
M I
ARCO EDICAL MAGING
B M
ARCO EDICAL
M I
EDICAL MAGING
S CD-ROM.
YSTEM
D S drivers, software or
ISPLAY YSTEM
I D S
MAGING ISPLAY YSTEM
D S CD-ROM into your
ISPLAY YSTEM
M
ARCO
drivers with
I
EDICAL MAGING
47