Table of Contents
Advertisement
Display controller installation
Installing the BarcoMed N
Install the BarcoMed N
steps:
Turn off the power to your computer and disconnect the power
1.
cord, however make sure that the computer chassis is still
grounded.
Remove the chassis cover according to the manufacturer's
2.
instructions. Be sure to observe safety warnings.
If you have decided to use the on-board VGA capabilities of the
3.
BarcoMed N
BarcoMed N
remove any VGA display controller(s) that are currently installed in
the computer or disable any VGA controllers that are integrated
into your PC's motherboard.
Install the BarcoMed N
4.
either 64-bit or 32-bit (see figure 5, for examples of slots). Be sure
that the display controller is seated firmly in the slot.
Secure the card to the chassis with the PC's I/O panel mounting
5.
screw, and replace the chassis cover.
Connect the primary display to the connector marked "VID 1" on
6.
the BarcoMed N
32
Figure 5: PCI and RAID Controller Slots
display controller
IO
controller in your computer following these
IO
(see Using the VGA capabilities of the
IO
display controller on page 30), you must now
IO
display controller into a free PCI slot,
IO
display controller using the provided DVI cable
IO
Nio systems
Advertisement
Table of Contents
