Diagnostics; Ping Test - Aztech Ethernet USB Combo Router User Manual

Diagnostics

Diagnostic Test is used for investigating whether the router is properly connected to the
WAN Network. This test may take a few seconds to complete. To perform the test, select
your connection from the list and click Test. Before running this test, make sure you have
a valid DSL link.
Diagnostics
To run diagnostic test:
1. From the Advanced Menu, select Diagnostics. This opens the Diagnostics page.
2. Click Test. The test status will appear after running the diagnostic test. If a test
failed, click Help to get the solution.

Ping Test

Once you have your router configured, it is a good idea to make sure you can ping the
network. If you can ping an IP on the WAN side successfully, you should be able to surf
the Internet.
To perform a ping test:
1. From the Advanced Menu, select Diagnostics. This opens the Diagnostics page.
2. Click Ping Test. This opens the Ping Test page.
3. Change or leave the default settings for the following fields:
IP address to ping
User Manual
Page 85 of 92