Table of Contents
Advertisement
User Manual
LAN
The router is preconfigured to automatically provide an IP address to each Ethernet
device connected in the local area network (LAN). However, if you are familiar with your
network setup, you can manually configure the LAN settings.
LAN Configuration
Your router's default IP address and subnet mask are 192.168.1.1 and 255.255.255.0,
respectively. This subnet mask allows the router to support 254 users. If you want to
support more users, you need to edit the subnet mask but remember that the DHCP
server function can only provide up to 255 IP addresses. If you change your gateways' IP
address and you have DHCP enabled, the DHCP configuration must reside within the
same subnet. The default gateway is the routing device used to forward all traffic that is
not addressed to a station within the local subnet. Your ISP will provide you with the
default gateway Address.
LAN Configuration
Page 35 of 92
Advertisement
Table of Contents
Need help?
Do you have a question about the Ethernet USB Combo Router and is the answer not in the manual?
Questions and answers