Knife Control - Avery Dennison Monarch 9855 RFID Operator's Handbook Manual

K n i f e C o n t r o l
You may notice unevenly cut tags on one end or the other of your supply
(one end may appear longer than the other). Use the knife control
adjustment to balance the cut tag length from tag-to-tag.
You may need to make this adjustment
♦ on initial printer setup.
♦ if you load a different supply type (thickness) from the last ones printed.
♦
when you change the print speed.
♦ when you change to a different tag size from the last ones printed.
To change the setting, from the Main Menu, select Setup, then Supply.
Then, follow these steps.
1. Press or
SUPPLY
Knife Ctrl
2. Press Enter/Pause. The current setting is displayed, for example:
Enter knife ctrl
[-20/20]: +0
Press or
3.
and cut a few test tags to check the tag cut length. Pressing
decreases the value;
Note: Depending on how unevenly the tags are cut, always start with a
small number, such as +- 1 or 2.
Press Enter/Pause when the number you need appears.
4.
Press Escape/Clear until you see the Main Menu.
4-16 Operator's Handbook
until you see
to change the knife control. You may need to experiment
increases it.