Using The Control Panel; Selecting A Function; Exiting A Function; Sleep Delay - Avery Dennison ADTP-1 Operator's Handbook Manual

For Ethernet Communications:
If you are using Ethernet communications, you can
monitor the status using the LEDs as shown:
Top LED:
Blinking
green
Bottom LED:
Orange
U s i n g t h e C o n t r o l P a n e l
The control panel has an LCD display and five buttons. The top three buttons are
function buttons, which vary depending on the task shown above the button. The two
bottom buttons are navigation buttons; use these to scroll through menus.
The LCD
♦
uses a red background when immediate attention (jam or error)
is required. For more information see Chapter 6
Troubleshooting."
♦
uses a green background when the printer is active
(printing or receiving data).
♦
uses a white background when viewing menu prompts,
printer settings, button functions, etc.

Selecting a Function

Your System Administrator can access the MENU to configure the printer.
♦
Press MENU.
♦ Press  or  to see the menu options.
♦
Press SELECT when you see the menu option you need.

Exiting a Function

There are two ways to exit an option. Pressing BACK once returns to the previous menu
and saves any changes. Pressing CANCEL exits to the previous menu; however,
changes are not saved.
Sleep Dela y
When the printer is idle for a selected period of time, it goes into sleep mode to conserve
power. Your System Administrator can adjust the Sleep Delay setting. The default setting
is 60 minutes. The printer wakes from sleep mode when it receives a print job, a button is
pressed, or the printhead is opened or closed.
1-4 Operator's Handbook
network activity/receiving data
a connection is present
Green LED
Orange LED
"Diagnostics &
M P C L
R E A D Y
1 9 2 . 0 . 0 . 1 9 2
F E E D T L A B E L M E N U