Tandem Operation (Tmod); Applicator Type (Appl); Ep Cylinder Dwell Time (Apt1); Blowing Time (Apt2) - Avery Dennison ALS 380 Operating Manual

4 O
PERATION
4.4 S
ETTINGS IN THE EXTENDED MENU
Tandem operation
4.4.16
Activate and deactivate tandem operation
– Refer to chapter Tandem operation in the service
guide.
Applicator type
4.4.17
When using an applicator (optional):
Set the applicator type used or switch off the applicator.
– Refer to chapter Applicator (optional), page 52.
EP cylinder dwell time
4.4.18
When using an EP applicator (optional):
Set the dwell time for the cylinders.
– Refer to chapter Applicator (optional), page 52.
Blowing time
4.4.19
When using a blowing applicator (optional):
Set the dwell time for blowing the label on the product.
– Refer to chapter Applicator (optional), page 52.
Delay time
4.4.20
When using an EP applicator (optional):
Delay of the signal air blow
– Refer to chapter Applicator (optional), page 52.
Fine tuning of the dwell time
4.4.21
(APT4)
When using an applicator (optional):
Fine adjust the dwell time of the applicator in combina-
tion with the automatic dispensing speed adjustment.
By doing this, the accuracy of the label position on the
product can be optimised.
– Refer to chapter Applicator (optional), page 52.
(TMOD) Delete a product data bank
4.4.22
load
Selecting and loading a product data bank.
– Refer to chapter Product databanks, page 48.
(APPL)
Create/save product data bank
4.4.23
(SAVE)
Create a new product data bank.
– Refer to chapter Product databanks, page 48.
Delete a product data bank
(APT1)
4.4.24
(DEL)
– Refer to chapter Product databanks, page 48.
(APT2)
(APT3)
66
ALS
380
(LOAD)