Insert New Label Roll - Avery Dennison ALS 380 Operating Manual

3 P
RIOR TO OPERATING
3.1 I
NSERT THE LABELLING MATERIAL

Insert new label roll

Only top-labeller:
➔
Loosen the set-screw at the guiding rod [13C] and
swing the guiding rod to the side.
All design versions:
➔
Rotate the knurled knob [13B] clockwise, to retract
the chucking wedge [13A] in the unwinding spindle.
➔ If there is still an old roll core on the unwinding spin-
dle: remove the old roll core.
➔
Completely push on the new label roll.
➔
Rotate the knurled knob counter-clockwise to se-
cure the label roll on the unwinding spindle.
Also for top-labeller:
Also secure the label roll to the dancer arm in the axial
direction:
➔ Allow the dancer arm to lightly rest against the label
roll and
➔
swing it approximately 1 cm over the unwinding
spindle. The dancer arm must not be allowed to
touch the unwinding spindle.
➔
Tighten the set-screw at the guiding rod.
A
B
[13] New label roll on the unwinding spindle, secured to the guiding
rod on the side
A Chucking wedge in the unwinding spindle
B Knurled knob on the unwinding spindle
C Guiding rod
22
ALS
380
C