6
O
PERATIONAL MALFUNCTIONS
6.1 W
ARNING MESSAGES
6
O
P E RA TI ON A L M AL FU NC TI ON S
6.1
WARNING MESSAGES
Please observe:
6.1.1
CAUTION!
Improper handling of the machine, especial-
ly changes to the settings, can lead to seri-
ous damage to the machine and system and
can cause work-related accidents!
– Only the responsible servicing techni-
cians or customer service personnel are
authorized to make changes to the set-
tings in the configuration menu.
➔
Ensure that the other settings are carried
out exclusively by specifically trained
and knowledgeable personnel.
Observe the expert symbols.
➔
Observe the additional information in this
operating instruction or in the service
guide.
Warning messages
6.1.3
Message
Description
W__0
Product was not labelled.
If a problem occurs
6.1.2
The control system detects a problematic or unaccept-
able situation:
– A warning message is displayed on the operator
panel.
– As a rule, the labelling operation is continued, if the
operator does not stop the machine.
If the cause of the warning message is eliminated:
– The warning code is no longer displayed.
Possible causes and remedies
➔
Remove the unlabelled product.
Several labels are missing from the label ribbon:
➔
Replace the label roll if the error occurs frequently.
The distance between the products on the conveyor
belt is insufficient:
➔
Increase the product distance.
➔
For circumferential labelling: Increase the rotation-
al speed.
The product triggers several start signals, caused by
reflections, for example:
➔
Adjust the product length (PRDL).
When using a printer, the printing time is too long:
➔
If possible, decrease the printer dwell time
(PDWT).
➔
Start printing process before label stop (PDT).
76
ALS
380