Patton electronics SmartNode Series Software Configuration Manual page 397

SmartWare Software Configuration Guide
there is no AOC information from the network. In that case a message containing the value noChargeAvailable
is sent.
Step
1
node(ctx-ip)[ctx-name]# interface isdn
<if-name>
2
node(if-isdn)[if-name]# aoc-s automatic Enables the transmission of AOC-S messages even
3
node(if-isdn)[if-name]# aoc-d automatic Enables the transmission of AOC-D messages even
4
node(if-isdn)[if-name]# aoc-e automatic Enables the transmission of AOC-E message even
The following procedure enables the transmission of AOC message on a per-call basis. That is AOC messages
are sent by the connected phone only if configured for a per-call basis.
Step
1
node(ctx-ip)[ctx-name]# interface isdn
<if-name>
2
node(if-isdn)[if-name]# aoc-s explicit
3
node(if-isdn)[if-name]# aoc-d explicit
4
node(if-isdn)[if-name]# aoc-e explicit
ISDN interface configuration task list
Command
Command
34 • ISDN interface configuration
Purpose
Go to the ISDN network interface, for which you
want to enable AOC for all calls
if there is no tariff information from the network for
all calls
if there is not charge information from the network
for all calls
if there is no charge information from the network
for all calls
Purpose
Go to the ISDN network interface, for which you
want to enable AOC on a per-call basis
Enables the transmission of AOC-S messages even
if there is no tariff information from the network on
a per-call basis
Enables the transmission of AOC-D messages even
if there is not charge information from the network
on a per-call basis
Enables the transmission of AOC-E message even
if there is no charge information from the network
on a per-call basis
397