Trip Computer - Volvo XC90 Owner's Manual

Trip computer

Controls
To access the trip computer information, you
must turn the ring (B) in steps, either forward
or backward. By turning again, you return to
the starting point.
NOTE! If a warning message interrupts while
you are using the trip computer, you must first
acknowledge the message by pressing the
READ button (A) to return to the trip
computer.
Functions
The trip computer displays the following
information:
• AVERAGE SPEED
• SPEED IN MILES PER HOUR
• CURRENT FUEL CONSUMPTION
• AVERAGE FUEL CONSUMPTION
• RANGE TO EMPTY FUEL TANK
Average speed
The average speed since the last reset
(RESET). When the ignition is switched off,
the average speed is stored and used as the
basis of the new value when you continue
driving. This can be reset with the RESET
button (C) on the lever.
Speed in miles per hour
Current speed is displayed in mph.
Current fuel consumption
Continuous information on current fuel
consumption, calculated each second. The
figure in the display is updated every couple
of seconds. When the car is stationary, "----"
is shown on the display.
NOTE! There may be a slight error in the
reading if a fuel-driven heater is used.
Average fuel consumption
The average fuel consumption since the last
reset (RESET). The average fuel
consumption is stored when the ignition is
switched off and remains until reset with the
RESET button (C) on the lever.
NOTE! There may be a slight error in the
reading if a fuel-driven heater is used.
1
1. Certain countries
Range to empty fuel tank
Displays the approximate distance that can
be driven with the fuel remaining in the tank,
the calculation is based on the average fuel
consumption over the last 30 km and the
remaining fuel volume. When the range to
empty is less than 20 km "----" appears on the
display.
NOTE! There may be a slight error in the
reading if a fuel-driven heater is used.
1
Instruments and controls
RN