Volvo XC90 Owner's Manual page 66

Manual climate control, A/C
– Press for more than 3 seconds.
The LED flashes for 5 seconds. The air
recirculates in the car for 3- 12 minutes
depending on the outside temperature.
– The timer function is activated each time
you press .
To switch off the timer function:
– Press again for more than
3 seconds. The LED lights for 5 seconds
to confirm your selection.
Recirculation is always disconnected when
you select Defroster.
3. Air distribution
Use the air distribution control positions
(marked with dots) between the different
symbols to fine-tune air distribution for
maximum comfort.
Air distribution Use
Air through When you want
front and good cooling in a
rear air warm climate.
vents.
Air distribution Use
Air to When you want to
windows. remove ice and
Air is not misting. High fan
recirculated in this speed is good for
position. The air this.
conditioning is
always connected.
There is a certain
amount of airflow
to the air vents.
Air to both When you want
floor and comfortable condi-
windows. tions and good
There is a certain demisting in a cold
amount of airflow climate. Not too
to the air vents. low a fan speed.
Air to floor. When you want to
There is a warm your feet.
certain
amount of airflow
to the air vents and
the defroster vents
for the windscreen
and side windows.
Air to floor In sunny weather
and air with cool outside
vents. temperatures.
Climate control
4. Rear window and door mirror
defroster
Use this button to quickly remove misting and
ice from the rear window and door mirrors,
see page 50 for further information about this
function.
5. Heated front seats
Do as follows for heated front seat(s):
– Press once: High heat – both LEDs in the
switch light up.
– Press twice: Low heat – one LED in the
switch lights up.
– Press yet again: Heating is switched off –
no LEDs in the switch are lit.
An authorised Volvo workshop can adjust the
temperature.
6. and 7. Heating/Cooling
– left/right side
Turn to set how warm or cold the incoming air
should be. For cooler air, the air conditioning
must be connected.
8. Fan
Fan speed can be increased or decreased by
turning the knob.
SR