Vivotek IP7361 User Manual page 79

Custom Command
If Custom Camera (scanner) is selected as the PTZ driver, you will need to configure command buttons
to control the PTZ scanner. Click Custom Command to open the Custom Command page to set the
commands in the Control Settings session. Please refer to your PTZ scanner user's manual to enter the
commands in the following fields. Click Save to enable the settings and click Close to exit the page�
►The command buttons will be displayed on the main page:
NOTE
►If you select DynaDome/SmartDOME, Lilin
PIH-7x00, or Pelco D protocol as the PTZ
driver, the Control Settings column will not
be displayed�
►For all PTZ drivers, a total of five additional
command buttons can be configured.
VIVOTEK
User's Manual - 79