Installing And Removing The Memory Modules; Installing & Removing Dimms; Removing Memory Modules - Supero X9DBU-iF User Manual

2-4

Installing and Removing the Memory Modules

Note: Check Supermicro's website for recommended memory modules.
Exercise extreme care when installing or removing DIMM
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with P1-
DIMM #1A. (For best memory performance, please use the modules of the
same type and speed in the same bank.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
LED3
JPL1
LAN2
LAN
CTRL
82580
LED1
BMC
CTRL
JI2C1
1
JI2C2
1
XDP_CPU
1 1
2
3 4
1
JPG1
Battery
XDP_PCH
I-SATA5
I-SATA4
I-SATA3
I-SATA2 Intel IOH
I-SATA1
BIOS
I-SATA0
X9DBU
Rev. 1.02
JBT1
BUZZER
JL1
SAS4~7 SAS0~3 FAN3
JF1
JD1
3. Align the DIMM module key with the receptive point on the memory slot.
4. Align the notches on both ends of the module with the receptive points on
ends of the slot.
5. Use two thumbs together to press the notches of the module straight down
into the slot until the module snaps into place.
6. Press the release tabs to the locked positions to secure the DIMM module
into the slot.
Press both notches straight
down into the memory slot at
the same time.

Removing Memory Modules

Press both notches on the ends of the DIMM module to unlock it. Once the DIMM
module is loosened, remove it from the memory slot.
CAUTION
modules to prevent any possible damage.
USB0/1
VGA COM1
LAN1 KB/MOUSE
JPW4
IPMI_LAN
PHY
JPW3
JPW2
JPW1
FAN1
FAN2
2-9
Chapter 2: Installation
Notches
Release Tabs