Hardware Installation - SIIG CyberParallel Dual Quick Installation Manual

Hardware Installation

General instructions for installing the card are provided
below. Since the design of computer cases and
motherboards vary, refer to your computer's reference
manual for further information, if needed.
Caution: Static Electricity Discharge may permanently
damage your system. To avoid possible static electricity
discharge during the installation, please follow the
guidelines below:
• Discharge any static electricity build up in your
body by touching a large grounded metal surface or
the computer's case (if plugged in), for a few
seconds.
• During the installation, avoid any contact with
internal parts. Handle cards only by their external
edges.
1. Turn OFF the power to your computer.
2. Unplug the power cord and remove your computer's
cover.
3. Remove the slot bracket from an available PCI slot.
4. Carefully align the card to the selected PCI slot push
the board down firmly, but gently, until it is well
seated.
5. Replace the slot bracket's holding screw to secure
the card.
6. Replace the computer cover and reconnect the power
cord.
3