CyberSerial Dual PCIe Quick Installation Guide Introducing the CyberSerial Dual PCIe The CyberSerial Dual PCIe high-speed serial I/O card provides two additional 9-pin serial ports. Features and Benefits • Compliant with PCI Express Base Specification 1.0a • PCI Express 1-lane (x1) serial I/O card works with PCI Express slots with different lane width •...
Page 2
Layout Power connector* Fan-out cable connector Figure 1: Layout * Note: If the serial port requires power output, connect the system power source to board's power connector. However, most serial devices do not require additional power through the serial port. Refer to your serial device's manual for more information.
Mini 2-port fan-out cable 9-pin serial Board connector Figure 2: Mini 2-port fan-out cable Hardware Installation General instructions for installing the card are provided below. Since the design of computer cases and motherboards vary, refer to your computer’s reference manual for further information, if needed. Static Electricity Discharge may permanently damage your system.
Connect the Mini 2-port fan-out cable to the fan-out cable connector on the card. Driver Installation This section provides information on how to install the CyberSerial Dual PCIe drivers. Windows 7 (32-/64-bit) Right click Computer, click Manage, click Device Manager. Insert the driver CD.
Page 5
Under Other Devices, starting at the top, right click 16C95X Serial Port, then click Update Driver Software. Click Browse my computer for driver software. Type D:, click Next. (Change D: to match your CD/ DVD-ROM drive letter) At Windows has successfully updated your driver software, click Close.
Page 6
Insert the driver CD, check Include this location in the search, uncheck the other box. Note: Click Cancel at the CD AutoPlay box if prompted. For 32-bit: Type D:\XP-Later\32-bit, and click Next, then click Finish. (Change D: to match your CD- ROM drive letter) For 64-bit: Type D:\XP-Later\64-bit, and click Next, click Continue Anyway, then click Finish.
Page 7
For Windows Server 2008: Right click Computer, click Manage, double click Diagnostics, click Device Manager. Click on the + (plus sign) in front of Ports (COM & LPT), CyberSerial 16C950..should be displayed two times. Double click Multi-port Serial adapters, SIIG CyberPro 2S board should be displayed.
Changing COM Port Number Some serial devices need a specific COM port in order to work. If your serial device works properly, do not change this setting. From the Device Manager window double click Ports (COM & LPT), then double click the CyberSerial serial port you want to change.
Step 1: Submit your RMA request. Go to www.siig.com, click Support, then RMA to submit a request to SIIG RMA. Your RMA request will be processed, if the product is determined to be defective, an RMA number will be issued.
Page 12
Fremont, CA 94538-3152, USA Phone: 510-657-8688 CyberSerial Dual PCIe is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks of SIIG, Inc. Microsoft and Windows are registered trademarks of Microsoft Corporation. Other names used in this publication are for identification only and may be trademarks of their respective owners.