DP CyberSerial Dual PCI RJ Quick Installation Guide Introducing the CyberSerial Dual PCI The DP CyberSerial Dual PCI RJ high-speed serial I/O card provides two additional 9-pin serial ports. Features and Benefits • Conforms to PCI v2.2 Plug and Play •...
Page 2
Package Contents • DP CyberSerial Dual PCI RJ board • Spare low-profile bracket • RJ45 to DB9 cable • Driver CD • Quick installation guide Layout Power connector* J1, J2 Serial Port 2 Serial Port 1 RJ45 to DB9 cable Figure 1.
Hardware Installation Note: For Low Profile systems, replace the currently mounted bracket with the included Low Profile bracket. General instructions for installing the card are provided below. Since the design of computer cases and motherboards vary, refer to your computer’s reference manual for further information, if needed.
Driver Installation This section provides information on how to install the DP CyberSerial Dual PCI RJ drivers. Windows 95 At the Update Device Driver Wizard, click Next. Insert the driver CD, and click Other Locations. Type in D:\9x, click OK, then Finish. (Change D: to match your CD-ROM drive letter) From the Insert Disk window, click OK.
Page 5
From the main desktop, double click My Computer, Control Panel, System, then click Device Manager. Double click Ports (COM & LPT), CyberSerial PCI 16Cxxx... should be displayed two times. Double click Multi-function adapters, SIIG CyberPro 2S PCI board and PCI Function should be displayed. Windows NT 4.0 From the desktop click Start, then Run.
Page 6
To Verify Windows NT 4.0 Installation Click Start, Settings, Control Panel, double click Ports device icon. Two new COM ports will be assigned when successfully installed. Windows 2000 At the Found New Hardware Wizard, click Next. Select Search for a suitable driver for my device (recommended), and click Next.
Page 7
Device Manager. Click on the + (plus sign) in front of Ports (COM & LPT), CyberSerial PCI 16Cxxx... should be displayed two times. Double click Multifunction adapters, SIIG CyberPro 2S PCI board should be displayed. Windows Vista ™ At the Found New Hardware window, insert the driver CD, click Locate and install driver software (recommended), then click Continue.
Page 8
Click on the + (plus sign) in front of Ports (COM & LPT), CyberSerial 16Cxxx... should be displayed two times. Double click Multifunction adapters, SIIG CyberPro 2S PCI board should be displayed. Changing COM Port Address Some serial devices need a specific COM port in order to work.
Step 1: Submit your RMA request. Go to www.siig.com, click Support, then RMA to submit a request to SIIG RMA. If the product is determined to be defective, an RMA number will be issued. Step 2: After obtaining an RMA number, ship the product.
Page 12
6078 Stewart Avenue Fremont, CA 94538-3152, USA DP CyberSerial Dual PCI RJ is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks of SIIG, Inc. Microsoft, Windows and Windows Vista are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries.