Windows Nt 4.0 Driver Installation - SIIG CyberParallel Dual Installation Manual

Chapter 2
Hide thumbs Also See for CyberParallel Dual:
Table of Contents

Advertisement

2-2.2 Windows NT 4.0 Driver Installation

The Windows NT 4.0 drivers and associated files reside in
the NT subdirectory on the Driver Installation diskette.
Perform the following steps to install the Windows NT 4.0
drivers:
1
Boot up from Microsoft Windows NT 4.0.
2.
Insert the Driver Installation diskette in the floppy drive.
3.
From the desktop, double-click on My Computer, then
3 1/2 Floppy (A:) and NT subdirectory.
4. Double-click on the setup icon. When the program
opens to the "SIIG Cyber PCI Welcome" window, click on
Next to continue.
5.
From the "Choose Destination Location" window, click
Next to install the driver files in the default folder. Or
click Browse to change, then click Next to proceed.
6.
From the next "Setup Complete" window, click Finish.
7.
Remove the diskette and click on Finish to reboot your
system.
To verify successful installation:
1.
From the main desktop, click on My Computer, then
Control Panel.
2.
Double-click on the SIIG Cyber PCI icon. The assigned
system configuration will be displayed.
Note: During system startup after installing the
board, a non-conflicting system setting such as
base I/O address will be assigned. If you like to
change it to a specific setting, you can override the
assigned setting by going into the Control Panel,
SIIG Cyber PCI, Settings, then Advanced to
change it.
Installation
2-5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CyberParallel Dual and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents