Table of Contents
Advertisement
Note
The FP, FS, IP, IS, ZP, and
ZS commands apply only if
you connect pin 6 (zoom), 7
(focus), and/or 9 (iris) to the
lens control connector.
These pins determine if the
lens is in positional or speed
mode.
Note
The IA and IL commands
apply only if you use pin 8 on
the lens control connector.
This pin determines whether
the lens is in Auto or Local iris
mode. The Auto/Local option
only works for lenses that
have iris control.
Note
The commands for Zoom,
Focus, and Iris output to
servomotor mode or motor
mode must be configured to
match the switch settings.
See Configuration Settings.
28
AXCESS Programming
Configuration commands (Cont.)
Command
'LENS=SERVO'
'LENS=STANDARD'
'FP'
'FS'
'IA'
'IL'
'IP'
'IS'
'ZP'
'ZS'
'IRIS PRESET=POS'
'IRIS PRESET=SPEED'
'IRIS SIGNAL=M'
'IRIS SIGNAL=S'
Function
Set the lens settings to servomotor mode style. This
macro command sends the ZP, FP, IP, ZOOM
PRESET=POS, ZOOM SIGNAL=S, FOCUS PRESET=
POS, FOCUS SIGNAL=S, IRIS PRESET=POS, IRIS
SIGNAL=S commands at one time.
Set the lens settings to standard motor mode style. This
macro command sends the ZS, FS, IS, ZOOM
PRESET=SPEED, ZOOM SIGNAL=M, FOCUS PRESET=
SPEED, FOCUS SIGNAL=M, IRIS PRESET=SPEED, IRIS
SIGNAL=M commands at one time.
Set the lens' Focus mode to positional (default). This
command can be used only for servomotor mode.
Set the lens' Focus mode to speed. This command can
be used only for servomotor mode.
Set the lens' Iris mode to auto (default).
Set the lens' Iris mode to local.
Set the lens' Iris mode to positional (default). This
command can be used only for servomotor mode.
Set the lens' Iris mode to speed. This command can be
used only for servomotor mode.
Set the lens' Zoom mode to positional (default). This
command can be used only for servomotor mode.
Set the lens' Zoom mode to speed. This command can be
used only for servomotor mode.
Set the Iris voltage output to recall positional presets
(default). This is only applicable if the IRIS SIGNAL=S
command is in effect, and the IRIS switch is set to the S
position (servomotor mode).
Set the Iris voltage output to recall speed presets. (Shown
for future use. Unit is not capable of this mode.) This is
applicable only if the IRIS SIGNAL=S command is in
effect, and the IRIS switch is set to the S position
(servomotor mode).
Set the Iris output to be a motor output. This setting
corresponds to the M position (motor mode) setting on the
IRIS switch.
Set the Iris output to be a servomotor output. This setting
corresponds to the S position (servomotor mode) setting
on the IRIS switch.
AXB-F117 Stealth 1 Camera Controller
Advertisement
Table of Contents
