Setting Zoom, Focus, And Iris Switches To Servomotor Or Motor Mode; Setting The Rs-232 Dip Switch (S1) - AMX AXB-F117 Stealth 1 Instruction Manual

Note
You must configure the AXB-
F117 software to match the
switch settings. Refer to
Configuration Commands in
the AXCESS Programming
section.
Figure 6
Servomotor and motor
voltage switch settings
Figure 7
RS-232 communications
parameters DIP switch (S1)
AXB-F117 Stealth 1 Camera Controller

Setting zoom, focus, and iris switches to servomotor or motor mode

The AXB-F117 supports servomotor (+2.5 to +7.5 VDC operating range) and direct-
drive motor ( 6 VDC or 12 VDC operating range) lens control. Figure 6 shows
how to set the switches for servomotor mode (S) or motor mode (M). If you are using
a direct-drive lens, refer to the manufacturer's literature to set the VOLT switch for
6 or 12 VDC control.
Servomotor and motor voltage switch settings
Servomotor mode
VOLT
6 12
ZOOM
S M
FOCUS
S M
IRIS
S M

Setting the RS-232 DIP switch (S1)

The RS-232 DIP switch (S1) positions 1 and 2 set the stop and data bits, positions 3
through 5 set the parity, and positions 6 through 8 set the baud rate. Figure 7
shows the RS-232 DIP switch and Figure 8 lists their settings.
RS-232
S1
1 2 3 4 5 6 7 8
ON
Motor mode
( 6 VDC)
VOLT
6 12
ZOOM
S M
FOCUS
S M
IRIS
S M
Pre-Installation Settings
Motor mode
( 12 VDC)
VOLT
6 12
ZOOM
S M
FOCUS
S M
IRIS
S M
7