Setting Zoom, Focus, And Iris Jumpers To Servomotor Or Motor Mode - AMX AXB-F117 Stealth 1 Instruction Manual

Figure 4
Servomotor and motor
voltage jumper settings
Figure 5
DIP switches and control
mode/voltage switches
6 Pre-Installation Settings

Setting zoom, focus, and iris jumpers to servomotor or motor mode

The AXB-F117 supports servomotor (2.5 to 7.5 VDC operating range) and direct-
drive motor (-6 to +6 VDC or -12 to +12 VDC operating range) lens control. Figure 4
shows how to set the jumpers for servomotor mode (S) or motor mode (M). If you
are using a direct-drive lens, refer to the manufacturer's literature to set the P.
VOLT jumper for 6 or 12 VDC control.
Servomotor and motor voltage jumper settings
Servomotor mode
VOLT
6 12
ZOOM
S M
FOCUS
S M
IRIS
S M
Figure 5 shows the DIP switches and lens control switches accessible on the back
panel.
Motor mode
(-6 to +6 VDC)
VOLT
6 12
ZOOM
S M
FOCUS
S M
IRIS
S M
AXlink
LED
VOLT
6 12
1 2 3 4 5 6 7 8
ZOOM ON
S M
FOCUS
S M
1 2 3 4 5 6 7 8
IRIS
ON
S M
AXB-F117 Stealth 1 Camera Controller
Motor mode
(-12 to +12 VDC)
VOLT
6 12
ZOOM
S M
FOCUS
S M
IRIS
S M
RS-232
S1
S2
DEVICE