AMX DXLink Instruction Manual page 76

Network Configuration
4.
Once all actions in Step 3 are completed, the LEDs all turn off, indicating the Transmitter or
Receiver is ready to reboot.
The Transmitter or Receiver automatically reboots to complete the process.
To restore Wallplate TX or Decor Wallplate TX to its factory default firmware image:
Note: The ID Pushbutton and the Reset button are located on the left edge of the Wallplate TX and
on the front of the Decor Wallplate TX.
1.
Press and hold the ID Pushbutton. While the ID Pushbutton is down, press and release the Reset
button. Start counting when the NetLinx LEDs begin to flash in unison, not when the Reset button is
released.
2. After the LEDs complete the following sequence, release both buttons:



3. Upon release, the unit executes the following actions:
a. Restores itself to its factory firmware image.
b. Resets to factory default parameters*:
4.
Once all actions in Step 3 are completed, the LEDs all turn off, indicating the unit is ready to reboot.
The unit automatically reboots to complete the process.
* For a complete list of factory parameters, see the table on page 65.
Tip: To monitor the ID Pushbutton boot state of a module, see the "ID Pushbutton Boot and NetLinx
LED Behavior" table on the next page.
70
Once the unit has started booting up, all LEDs flash in unison at the rate of once per second.
After 10 flashes at that rate, the LEDs will blink in unison at a faster rate.
After 10 seconds of flashing at the increased rate, all LEDs go to solid on.
Deletes all IRL files stored on the device.

Resets to the default static IP address of 192.168.1.2 and default DHCP address of

169.254.2.2.
Resets to the default device number of 0 (when bound to a Master, it will receive a

dynamic device number from the Master).
Resets to NDP mode and being unbound.

Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver