AMX DXLink Instruction Manual page 58

Installation and Setup
Additional Wallplate TX and Decor Wallplate TX Functionality
The following items are on left edge of Wallplate TX and on front of Decor Wallplate TX.
Reset Button
The Reset button resets the unit's CPU (acts like a power cycle soft reboot).
Program Port
This port (USB mini-B connector) supports DGX Configuration software for programming a customer
VGA EDID.
ID Pushbutton
The ID Pushbutton places the unit in ID Mode for setting the NetLinx ID (device only) and provides
additional functionality, such as placing the unit in Static IP Mode or DHCP Mode (see page 66).
Wallplate TX and Decor Wallplate TX – Indicator LEDs
The Wallplate TX and Decor Wallplate TX receive power from a switcher through the DXLink (RJ-45)
connection to a DXLink Input Board in the switcher. They can also receive power via either PDXL-2
(FG1090-170) or PS-POE-AT-TC (FG423-84).
Important: We recommend determining the power budget to maintain power redundancy for the
system (see page 38).
Tip: If the Wallplate TX is installed in a location where it is difficult to check the LEDs on the bottom
edge, slide a white piece of paper or a small mirror under the edge to view LED status.
Wallplate TX and Decor Wallplate TX Indicator LEDs
LEDs
Digital Video
(default)
Analog Video
Audio
Power
LEDs (bottom edge of Wallplate TX)
NetLinx - L (Link)
NetLinx - S (Sta-
tus)
DXLink Yellow
DXLink Green
LEDs (on front of Decor Wallplate TX)
HDCP
DXLink
Status
Link/Act
* The LEDs for Digital Video, Analog Video, and Audio each indicate the configured state of the connectors, not
necessarily the presence of signals through the Wallplate TX or Decor Wallplate TX.
52
Normal Display
Green The Wallplate TX and Decor Wallplate TX have been configured*
to pass HDMI (for SEND_COMMAND information, see page 86)
One of the 3 LEDs The Wallplate TX and Decor Wallplate TX have been configured*
will be Green to pass one of the following types of analog video (for SEND_COM-
MAND information, see page 86):
• C (composite) or Y/c (two component)
• Y/PB/PR or RGB (three component)
• RGBHV (five component) or RGBS (four component)
Green The Wallplate TX and Decor Wallplate TX have been configured*
to pass analog audio as the audio source being embedded on the
DXLink output connection (coupled with either the analog or digital
video input path); for SEND_COMMAND information, see page 90
Green Power (from switcher or DXLink power injector) is applied
Green Active LAN connection to an AMX Network
Green • Speed status is 100 Mbps
Off • Speed status is 10 Mbps
Yellow • Authenticated HDCP (handshaking has occurred successfully)
Flashing • Video is active; no HDCP
Off • No Video
Green DXLink connection is established
Yellow • Authenticated HDCP (handshaking has occurred successfully)
Flashing • Video is active; no HDCP
Off • No Video
Green DXLink connection is established
Green • Speed status is 100 Mbps
Off • Speed status is 10 Mbps
Active LAN connection to an AMX Network
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Indicates
(Blinking = #3 Toggle OFF)
(Blinking = #3 Toggle OFF)