AMX DXLink Instruction Manual page 25

Receiver Module LEDs
HDMI RX Indicator LEDs
LED
Power
Video
Audio
Scaling:
– Bypass
– Auto
– Manual
IR TX
IR RX
Serial TX
Serial RX
NetLinx Link/Act
NetLinx Status
CEC
USB
* When the output cable is disconnected from the HDMI RX or if no EDID can be found on the destination device,
the last used Scaling Mode LED will be ON. In either case, the HDMI RX will continue to hold its output resolution
to the last known preferred resolution until a power cycle or reconnection of a sink with a valid EDID. On power
up without a valid EDID, the default preferred output resolution presented will be 1280x1024 @ 60 Hz until a
different EDID is detected.
Note: For detailed behavior of the NetLinx Link/Act and Status LEDs on the module's front, see
page 61. For detailed behavior of the RJ-45 connectors' LEDs on the module's rear, see page 48
through page 48.
Receiver Rear View
Power jack
Ground screw
FIG. 9
HDMI RX rear view
The following components are located on the rear of the HDMI RX (left to right):
Power Jack
Important: If desktop power is used to power the Receiver, only the provided desktop power supply
should be used and it must not be altered in any way. Remote power can also be provided via a
switcher, PDXL-2 (FG1090-170), or PS-POE-AT-TC (FG423-84).
The power receptacle is a 2.1 mm DC jack for connecting power. Power can come from a locally
connected DC supply of 12 V. An automatically adjusting universal 110/220 IEC power supply is
provided. The power supply is ENERGY STAR
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Normal Display
Green Power is applied to the Receiver
Green A video signal is present through the Receiver
Green An embedded audio signal is present through the Receiver
The Receiver is in one of the three modes for scaling
One LED is green • At initial power up, the Receiver defaults to the Auto scaling
The other two are off option*
• Pressing the Scaling button cycles the module through the
options: Bypass, Auto, and Manual
• If Bypass is solid and Auto is flashing, then the RX is trying to read
EDID from the sink
Red IR TX active communication
Yellow IR RX active communication
Red Serial TX active communication
Yellow Serial RX active communication
Green Active LAN connection to an AMX Network
Green LAN connection is active
OFF CEC is not currently supported
Yellow USB is not currently supported (this functionality will be
available in a future firmware upgrade)
DXLink input connector
ICS LAN 10/100 connector
Product Overview and Specifications
Indicates
USB port Stereo Audio Out connector
RS-232 port
IR ports
®
qualified to ensure maximum efficiency and savings.
(Blinking = #3 Toggle OFF)
HDMI Out connector
19