AMX DXLink Instruction Manual page 20

Product Overview and Specifications
Wallplate TX and Decor Wallplate TX Front LEDs
Wallplate TX and Decor Wallplate TX Indicator LEDs
LEDs
Digital Video
(default)
Analog Video
Audio
Power
LEDs (bottom edge of Wallplate TX)
NetLinx - L (Link)
NetLinx - S (Status)
DXLink Yellow
DXLink Green
LEDs (under customer provided front cover plate on Decor Wallplate TX)
HDCP (DXLink)
DXLink
Status (NetLinx)
Link/Act (NetLinx)
* The LEDs for Digital Video, Analog Video, and Audio each indicate the configured state of the connectors,
not necessarily the presence of signals through the Wallplate TX and Decor Wallplate TX.
Note: Detailed behavior for the NetLinx-L and NetLinx-S LEDs on the Wallplate TX or Link/Act and
Status LEDs on the Decor Wallplate TX are on page 61, and basic information for the LEDs on the
RJ-45 connector on the rear of the Wallplate TX and Decor Wallplate TX is on page 48.
Tip: If the Wallplate TX is installed in a location where it is difficult to check the LEDs on the bottom
edge, slide a white piece of paper or a small mirror under the edge to view LED status.
14
Normal Display
Green The Wallplate TX and Decor Wallplate TX have been configured*
to pass HDMI (for SEND_COMMAND information, see page 86)
One of the 3 LEDs The Wallplate TX and Decor Wallplate TX have been configured*
will be Green to pass one of the following types of analog video (for
SEND_COMMAND information, see page 86):
• C (composite) or Y/c (two component)
• Y/PB/PR or RGB (three component)
• RGBHV (five component) or RGBS (four component)
Green The Wallplate TX and Decor Wallplate TX have been configured*
to pass analog audio as the audio source being embedded on the
DXLink output connection (coupled with either the analog or digital
video input path); for SEND_COMMAND information, see page 90
Green Power (from switcher) is applied to the unit
Green Active LAN connection to an AMX Network
Green • Speed status is 100 Mbps
Off • Speed status is 10 Mbps
Yellow • Authenticated HDCP (handshaking has occurred successfully)
Flashing • Video is active; no HDCP
Off • No Video
Green DXLink connection is established
Yellow • Authenticated HDCP (handshaking has occurred successfully)
Flashing • Video is active; no HDCP
Off • No Video
Green DXLink connection is established
Green • Speed status is 100 Mbps
Off • Speed status is 10 Mbps
Green Active LAN connection to an AMX Network
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Indicates
(Blinking = #3 Toggle OFF)
(Blinking = #3 Toggle OFF)