Device Ids; Using The Id Pushbutton - AMX DXLink Instruction Manual

Dxlink twisted pair transmitters/receiver dxlink multi-format wallplate transmitter dxlink multi-format decor style wallplate transmitter (us) dxlink multi-format transmitter module dxlink hdmi transmitter module dxlink hdmi receiver module
Hide thumbs Also See for DXLink:
Table of Contents

Advertisement

Network Configuration

Device IDs

Device IDs
Model
HDMI-TX Module
(AVB-TX-HDMI-DXLINK)
Multi-Format TX Module
(AVB-TX-MULTI-DXLINK)
Multi-Format Wallplate TX
(AVB-WP-TX-MULTI-DXLINK)
Decor Wallplate TX
(AVB-DWP-TX-MULTI-DXLINK)
HDMI-RX Module
(AVB-RX-DXLINK-HDMI)

Using the ID Pushbutton

The ID Pushbutton is located on the right front of the modules, on the left edge of the Wallplate TX, and
on the front of the Decor Wallplate TX.
FIG. 37
ID Pushbutton on module (HDMI TX shown)
The ID Pushbutton can be used to perform four types of initial configuration settings:




The functions performed depend on when and for how long the ID Pushbutton is pressed and held.
ID Pushbutton functions can also be implemented using Telnet commands (see page 111).
Tip: To monitor the ID Pushbutton boot state of a module by its NetLinx LED behavior, see page 71.
Toggling Between IP Addressing Modes: DHCP and Static IP
DXLink Transmitters and Receivers support both DHCP and static IP addresses. When the #3 Toggle
is ON (see page 42), the modules automatically use DHCP with link-local fallback. However, you can
use a static IP address which can be set via a Telnet command (SET IP), or you can use the factory
default static IP address. The default static IP address can be recalled at any time by resetting the unit to
its factory default configuration (see page 68). The default dynamic (DHCP) address is 169.254.2.2.
The ID Pushbutton can be used to toggle between the DHCP and Static IP Modes.
66
Toggle between DHCP and static IP addressing (see below)
Assign a device address (page 67)
Reset the unit to its factory default settings, which affects the parameters but not the firmware
version (see page 68)
Restore the unit to its factory firmware image, which affects both the firmware version and the
parameters (see page 69)
ID (16-bits) Bound
0x017C
0x017F
0x017E
0x018B
0x017D
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
ID (16-bits) Unbound
0x014B
0x014B
0x014B
______
0x014B
ID Pushbutton

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents