Product Overview and Specifications
DXLink Multi-Format Wallplate TX (AVB-WP-TX-MULTI-DXLINK) Front View
Left edge
Reset button
Program port
ID Pushbutton
FIG. 3
Multi-Format Wallplate TX front view, plus left edge and bottom edge views
Components located on front of Wallplate TX:
Components located on left and bottom edges of Wallplate TX:
12
Bottom edge
NetLinx LEDs
HDMI In – HDMI connector (with locking center screw) for digital video and embedded
digital audio (supports a DVI-D signal with use of DVI-to-HDMI cable adapter). When more
than one audio signal is present, HDMI embedded audio takes precedence over analog audio.
–
Digital Video LED
Indicates the unit is configured to pass HDMI with embedded audio
(default).
Video In – An HD-15 connector for analog video: C (composite), Y/c, Y/Pb/Pr, RGB,
RGBHV, or RGBS. Pinouts for analog video are on page 128.
–
Analog Video LEDs
Illuminates when the Wallplate TX is configured to pass analog video:
composite or Y/c; Y/Pb/Pr or RGB; RGBHV or RGBS.
–
Audio In Stereo
Audio connector is a 3.5 mm stereo jack. An analog audio signal is only
available when HDMI embedded digital audio is not present (or configured for analog audio).
–
Audio LED
Indicates the unit is configured to pass analog audio (coupled with digital or
analog video path).
USB Host port – Mini-B USB connector (supports USB host) for receiving keyboard / mouse
commands from a specific RX. (USB port will be supported in a future firmware upgrade.)
–
Power LED
Indicates when the Wallplate TX is powered on.
–
Reset button (left)
Resets the Wallplate TX's CPU (acts like a power cycle soft reboot)
–
Program port (left)
This port (USB mini-B connector) supports DGX Configuration
software for programming a customer VGA EDID.
ID Pushbutton (left) – Places the Wallplate TX in ID Mode for setting the NetLinx ID (device
only) and provides additional functionality, such as placing the device in Static IP Mode or
DHCP Mode.
–
NetLinx LEDs (bottom)
Left green LED (L = Link/Act) indicates network communication
activity; right green LED (S = Status) indicates unit status
–
DXLink LEDs (bottom)
Left yellow LED indicates HDCP status; right green LED indicates
that a valid DXLink connection has been established.
DXLink LEDs
.
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
HDMI Input
Digital Video LED
HD-15 Input
Analog Video LEDs
Audio LED
Stereo Audio Input
USB Host
Power LED
.