Installing The Switch On A Desktop; Figure 6. Attaching The Rubber Feet - Allied Telesis AT-9000/24 Installation Manual

Installing the Switch on a Desktop

You can place AT-9000/24 Gigabit Ethernet Switch on a desktop or install
it in a 19-inch rack. To install the switch in a rack, refer to "Installing a
Switch in a Rack" on page 36.
To place the switch on a desktop, perform the following procedure:
1. Remove all equipment from the package and store the packaging
material in a safe place.
2. Turn the switch over and attach the four rubber feet to the bottom of
the switch as shown in Figure 6.

Figure 6. Attaching the Rubber Feet

3. Turn the switch over again and place it on a flat, secure surface (such
as a desk or table) leaving ample space around the unit for ventilation.
AT-9000/24 Layer 2 Gigabit Ethernet Switch Installation Guide
24 23
22 21
SFP
ACT LINK
10/100 1000
ACTIVITY PORT
24R 22R 20 18 16 14 12 10 8 6 4 2 POWER
23R 21R 19 17 15 13 11 9 7 5 3 1
Switch Ethernet Gigabit Port 24
AT-9000/24
796
35