Installing Countertop Dispenser With Legs Accessory - Follett C/E12CI400A Installation, Operation & Service Manual

Fig. 2 – Bottom exiting utilities
(countertop units)
19mm (3/4") FPT drain
10mm (3/8") push-in
water inlet elbow
Installing countertop dispensers
with legs accessory
1. Carefully tip dispenser back to expose underside and
block up in place.
Note: Do NOT tilt unit farther than 30° off vertical plane.
2. Screw legs (shipped taped to drain pan of dispenser)
into dispenser bottom, taking care to seat legs securely
against underside of dispenser.
Note: Countertop dispensers that sit on legs (not bolted
to counter) can be inadvertently moved. Care should be
taken when operating and cleaning to avoid accidents.
3. Attach bottom panel and hardware to bottom of
dispenser with supplied screws (Fig. 4).
4. Position unit in desired location and adjust bullets on
legs to level in both directions.
5. Make final connections.
Pipe plug may be moved to back
of unit for alternate drain hook up
Poly tubing and elbow may be
removed for alternate water inlet
hook up by pushing in on the
locking collar while pulling out on
the tubing.
Fig. 3 – Rear exiting utilities
39mm
(1.5")
23mm (.9")
Fig. 4 – Bottom panel assembly
6
(countertop units)
407mm (16")
298mm
(11.7" )
206mm
(8.1")
DRAIN
ICE MACHINE
MAKE-UP WATER
10mm (3/8") FPT
water inlet
19mm (3/4")
FPT drain
power cord
COUNTER TOP DISPENSER WITH LEGS
bottom
panel
screw
leg