Table of Contents
Advertisement
5.
Lift the edge of the side cover slightly at the two points
shown, and pull the cover away from the printer at the
top. Lift the cover slightly to detach it from the printer.
Place it safely to one side.
6.
Identify the six locating holes indicated in the illustration,
which will be used to locate the disk unit onto the side of
the printer.
7.
With the component side of the disk unit facing the
printer, and the connector cable towards the rear, lift the
disk unit handle away from the disk body.
8.
Plug the end of the connecting cable (1) into the disk unit
connector (2) in the printer.
9.
Locate the six legs of the disk unit into the mounting holes
on the printer.
10.
Push the handle flat against the disk unit, which will lever
the unit slightly towards the rear of the printer, locking it
into place.
11.
Locate the three retaining clips at the bottom of the side
cover into their rectangular holes near the bottom of the
printer.
12.
Close the top of the side cover up to the printer and refit
the securing screw removed in step 4.
Installing upgrades> 95
1
2
Advertisement
Table of Contents
