NAPCO Gemini GEM-P3200 Installation Instructions Manual page 28

!
Page 28
TO ARM IN 1-4 HRS. (Not for UL Installations.)
Use this function to (a) delay programmed autoarming up to 4 hours, 15 minutes or (b) initiate autoarming in 4 hours, 15
minutes as follows. Note: Autoarming may not be used in UL installations.
At the "AUTOARM IN 1-4HR" display:
For 1hr, 15min delay: press the
For 2hr, 15min delay: press the
For 3hr, 15min delay: press the
For 4hr, 15min delay: press the
Fifteen minutes prior to arming, the siren will sound a 2-second warning and the keypad will begin a 15-minute
countdown with the sounder pulsing. (The sounder may be silenced by pressing the
on one minute before arming.) Within this countdown window, arming may be delayed an additional 1 to 4 hours, as
above, or autoarming may be canceled by arming and disarming the panel.
DISPLAY AUTO ARM SCHD (Not for UL Installations)
Press YES ( button) to display the autoarm schedule programmed by the PCD3000 software. Use NEXT (
E
and PRIOR ( ) button to scroll forward and back through the week. While the programmed schedule cannot be
E
changed at the keypad, autoarming may be delayed up to four hours at the keypad, or it may be totally disabled, up to
one week in advance. Select the day using the NEXT (
hours) or disable using the the
the keypad will begin a 15-minute countdown with the sounder pulsing. Within this countdown window, arming may be
delayed an additional 1 to 4 hours (using TO ARM IN 1-4HRS function), or autoarming may be canceled by arming and
disarming the panel.
ACTIVATE PROGRAM
At Keypad No. 1, press YES (the
(Program-2) Mode, depending upon the code entered. Scroll through the programmable functions using NEXT (the
button) and PRIOR (the
E
may be located in any area.
ACTIVATE DOWNLOAD
Used on-site for remote downloading of a control-panel program from the PCD3000. Press YES (the
initiate the data transfer.
DISPLAY RF XMITTER STAT
Press YES (the button) to check the status of up to 48 transmitters. The keypad will display:
E
!
zone number (Z01-Z48)
!
transmitter ID code number (6 digits)
!
point number (PT1-PT4; "9" for unsupervised)
! status of transmitter:
NODATA: transmission not yet received
NORMAL: transmitter's zone normal;
FAULT: transmitter's zone open;
LOBATT: transmitter battery low;
TAMPER: transmitter case open;
S.FAIL: supervisory failure (test transmission not received within programmed time);
X
GEM-P3200 Installation Instructions
J
button, then the
1
J
button, then the
2
J
button, then the
3
J
button, then the
4
E
J
button. Fifteen minutes prior to autoarming, the siren will sound a 2-second warning and
button) to activate the User Program (Program-1) Mode or Dealer Program
E
button). To exit this mode at any time, press
F
button.
button.
button.
button.
) and PRIOR ( ) buttons. Then select the delay (1-4
F
L
WI817C 08/00
button, but it will come back
C
. Note: Keypad No. 1
CC
button) to
E
NAPCO Security Systems
)
E