NAPCO Gemini GEM-P3200 Installation Instructions Manual page 2

THIS MANUAL INCLUDES FEATURES WHICH ARE ONLY AVAILABLE IN CONTROL PANEL
The following changes have been made to this manual (WI818D) since the last edition (WI818C).
New GEM-P3200 Version 20 Features:
!
New Easy Menu Programming allows the system to be completely programmed through Menu Driven Easy
Program Mode. Requires the use of the following version keypads:
GEM-RP1CAe2, Version 6
GEM-RP2ASe2, Version 5b
GEM-RP3DGTL, Version 1c
!
Maximum Wireless Zones expanded from 32 to 48
!
Maximum Number of Users expanded from 32 to 48
!
Chime 2 zone provides second distinct pulsating "Chime Zone" tone
!
Set System Time and Date in User Program Mode
!
System Trouble Audible Automatic Timeout
!
Inhibit System Trouble Audible
!
Easy Programming of PC Preset Auto download ID and Callback Numbers
!
Support of GEM-PRINT module
!
Cancel Reporting Code
!
Wireless Trouble Reporting by Zone
!
Pager (Telco 3) Reporting Delay
!
Pager - Programmable Number of Reports of Same Signal
!
Pager - Maximum Number of Consecutive Pages
!
Specific Logging of Communication Failure Modes
!
New Relay Event "Area Disarmed" (PCD3000 programmable only)
!
Programmable DST start date (PCD3000 programmable only)
!
20 Digit Dialing Prefix
NOTE: Typically, any version GEM-P3200 control panel could be upgraded to the latest firmware by replacing the
EPROM with a newer version. This is no longer the case. The Firmware Version 20 EPROM must only be used in a
Version 18 (or greater) PCBoard. Do NOT attempt to upgrade a GEM-P3200 control panel which currently is running
Firmware Version 11C (or prior) to version 20 (or greater) by replacing the EPROM.
The PCBoard version ( triangle number) is printed on a triangular shaped sticker affixed to the GEM-P3200 circuit board.
FIRMWARE VERSION 20 OR LATER.
CHANGES FROM PREVIOUS EDITION
Upon entering program mode, the keypad display will flash the control panel
firmware version, followed by the keypad firmware version:
GEM-RP1CAe2: [2006], GEM-RP2ASe2: [205b], GEM-RP3DGTL: [20/1C]
NAPCO Security Systems, Inc.
333 Bayview Avenue, Amityville, New York 11701
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service, call toll free: (800) 645-9440
Internet: http://www.napcosecurity.com