Arcconf Setname; Arcconf Setncq; Arcconf Setperform; Arcconf Setpower - Adaptec Command Line Utility User Manual

arcconf setname

Renames a logical drive.
Syntax
ARCCONF SETNAME <Controller#> LOGICALDRIVE <LogicalDrive#> <New Name>
Parameters
Controller# is the controller number
LogicalDrive# is the number of the logical drive to be renamed
New Name is the new name of the logical drive
Example
ARCCONF SETNAME 1 LOGICALDRIVE 1 BACKUP_A

arcconf setncq

Changes the controller's Native Command Queuing (NCQ) setting to enabled or disabled.
This setting affects the SATA disk drives on the controller. It takes effect when the SATA drives
are restarted.
Syntax
ARCCONF SETNCQ <Controller#> ENABLE|DISABLE
Parameters
Controller# is the controller number.
Example
ARCCONF SETNCQ 1 ENABLE

arcconf setperform

Changes controller settings based on the application.
Syntax
ARCCONF SETPERFORM <Controller#> <Performance Mode>
Parameters
Controller# is the controller number.
Performance Mode is 1 (DYNAMIC/Default) or 2 (OLTP/Database).
Example
ARCCONF SETPERFORM 1 2

arcconf setpower

Changes power management settings for disk drives on a controller or logical drive.
Syntax
ARCCONF SETPOWER <Controller#> Stayawake DISABLE|<starttime> <endtime>
ARCCONF SETPOWER <Controller#> Spinup <internal#> <external#>
ARCCONF SETPOWER <Controller#> LD <LogicalDrive#> DISABLE|[SLOWDOWN <st#>]
[POWEROFF <pt#>] [VERIFY <vt#>]
Chapter 2: Using the Command Line Utility
27
●