Arcconf Setconfig; Arcconf Setmaxiqcache; Arcconf Setname - Adaptec 5405Z User Manual

arcconf setconfig

Resets the controller's configuration. Logical drives are deleted, hard disks are reset to the
READY state, and any controller settings are reset to default values.
Syntax
ARCCONF SETCONFIG <Controller#> DEFAULT [noprompt]
Parameters
Controller# is the controller number
Default restores the controller 's default configuration.
Noprompt: No prompt for confirmation.
Example
ARCCONF SETCONFIG 1 DEFAULT

arcconf setmaxiqcache

Enables/disables MaxIQ caching for a logical drive, adds a Solid State Disk (SSD) to the MaxIQ
pool, removes an SSD from the MaxIQ pool.
Note:
Before you can enable the
MaxIQ pool. Additionally, regular read caching must also be enabled (see
Syntax
ARCCONF SETMAXIQCACHE <Controller#> ENABLE|DISABLE <LogicalDrive#>
ARCCONF SETMAXIQCACHE <Controller#> ADDTOPOOL|REMOVEFROMPOOL <Channel# Device#>
...
Parameters
Controller# is the controller number
LogicalDrive# is the number of the logical drive
Channel# is the channel number for the SSD
Device# is the device number for the SSD
Example
ARCCONF SETMAXIQCACHE 1 ENABLE 1
ARCCONF SETMAXIQCACHE 1 ADDTOPOOL 0 1
ARCCONF SETMAXIQCACHE 1 REMOVEFROMPOOL 0 1 0 2

arcconf setname

Renames a logical drive.
Syntax
ARCCONF SETNAME <Controller#> LOGICALDRIVE <LogicalDrive#> <New Name>
Parameters
Controller# is the controller number
LogicalDrive# is the number of the logical drive to be renamed
New Name is the new name of the logical drive
Chapter 2: Using the Command Line Utility
MaxIQ
cache, you must assign at least one SSD to the
21
●
page 20).