Table of Contents
Advertisement
Fault Finding Chart (Automatic Line Feed only)
WARNING Disconnect from the mains electricity supply before attempting any maintenance or adjustment.
FAULT
LINE NOT FEEDING
OR
LINE TOO SHORT
OR
TRIMMER VIBRATES
CONTINUOUS
CLATTERING NOISE
LINE SNAPS CONTINUOUSLY
IF NONE OF THE ABOVE
OR IF FAULT PERSISTS
After you have finished using your Flymo Mini-Trim
follow the procedure below:
1. Disconnect from the mains electricity supply.
2. Never clean your trimmer with water, cleaning flu-
ids, or solvents, just remove debris with a suitable
tool, a soft brush or dry cloth.
3. Using a soft brush, clean around the inside of the
safety guard, the cutting head and the motor
housing air vents. (Fig S, T).
4. Inspect the trimmer carefully, especially the parts
of the cutting head.
5. If your trimmer is damaged in any way contact
your local Electrolux Outdoor Products approved
service centre.
•
Never use a damaged trimmer.
6. Wind cable carefully to avoid kinking.
7. Store in a cool, dry place and out of reach of chil-
dren.
Electrolux Outdoor Products are manufactured under an Environmental Management System (ISO 14001)
using, where practical, components manufactured in the most environmentally responsible manner, accord-
ing to company procedures, and with the potential for recycling at the end of the products' life.
•
Packaging is recyclable and plastic components have been labelled (where practical) for categorised
recycling.
•
Awareness of the environment must be considered when disposing of 'end-of-life' product.
•
If necessary, contact your local authority for disposal information.
•
Your product is uniquely identified by a silver and black product rating label.
•
We strongly recommend that your product is serviced at least every twelve months, more often in a pro-
fessional application.
CHECK
Is the automatic line feed work-
ing?
Is the line fed out and visible?
Has line been removed from
cleat?
Is the manual line feed working?
Has the motor reached full
speed before use?
Has too much line been fed out?
Is the line cutter missing from
the safety guard?
Are you using the trimmer cor-
rectly?
Is the line jamming on the
spool?
Contact Electrolux Outdoor Products Customer Service
Telephone : 01325 300303
Maintenance
S
T
Environmental Information
Service Recommendations
ACTION
No
Manually feed out line.
Remove cap and spool, free line
No
and re-fit spool and cap.
The line may be jammed on the
No
spool. Rewind line to remove
crossed loops. Check that line is
in correct section of spool.
Allow the motor to reach full speed
No
before use
Yes
Rewind line.
Contact your local approved Service
Yes
Centre or Electrolux Outdoor
Products Customer Service.
?
Only use tip of nylon line to trim.
Rewind the line on the spool, if
Yes
symptoms still persist, change
spool and line.
6
Hide quick links:
Advertisement
Table of Contents
