Flymo Contour PowerPlus Original Instructions Manual
Grass trimmer
Hide thumbs
Also See for Contour PowerPlus:
- Manual (80 pages) ,
- Original instructions manual (8 pages) ,
- Original instructions manual (10 pages)
Advertisement
Advertisement
Table of Contents
Related Manuals for Flymo Contour PowerPlus
Summary of Contents for Flymo Contour PowerPlus
- Page 1 ® Original Instructions...
-
Page 2: Carton Contents
Guard moulded on plug Wheel IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd. Customer Service Department direct Telephone : 0844 844 4558 UK... - Page 3 Do not repair a damaged cable, replace it with a new one. Use only Flymo replacement cable. if you hit an object. Do not use your trimmer until you are sure that the entire trimmer is in a safe operating 11.Always wind cable carefully, avoiding kinking.
-
Page 4: Assembly Instructions
Assembly Instructions Assembly of Switch Handle to Tube (A1) • Ensure that the internal cable is not twisted. 1. Insert the tube into the switch handle. 2. Push until it clicks into position. • ENSURE THAT THE TUBE IS FULLY LOCATED BY ATTEMPTING TO REMOVE IT. -
Page 5: Double Auto Feed System
Double Auto Feed System How the automatic line feed works (G) 1. When initially switching on the trimmer, a small length of line is fed out. 2. A ‘clattering’ noise will be heard when the two nylon lines hit the line cutter. DO NOT BE ALARMED this is quite normal. -
Page 6: Cutting Head
7. Refit the cap. To fit nylon line only: • Remember ! Your Flymo Trimmer is designed to use only nylon line with a maximum diameter of 1.5mm. Cleat Use only genuine Flymo nylon line. -
Page 7: Maintenance
Keep fingers and hands clear of the line cutter on leading edge of guard. Caring for your Contour Power Plus After you have finished using your Flymo Contour Power Plus follow the procedure below: AVOID ACCIDENTAL STARTING. REMOVE PLUG... -
Page 8: Fault Finding Chart
Fault Finding Chart WARNING Disconnect from the mains electricity supply before attempting any maintenance or adjustment. FAULT CHECK ACTION Is the automatic line feed work- Manually feed out line. LINE NOT FEEDING ing? SEE “MANUAL LINE FEED” Is the line fed out and visible? Remove cap and spool, free line LINE TOO SHORT Has line been removed from... -
Page 9: Ec Declaration Of Conformity
Our policy of continuous improvement means that the specification of products may be altered from time to time without prior notice. Copyright © 2011 Flymo S.A. All rights reserved. Flymo® and other product and feature names are registered or unregistered trademarks of Flymo S.A.